10G SFP+ ER

There are two main types of 10G optical modules, SFP+ optical modules and It has many advantages such as strong performance and has been widely used in data center networks.

The 10G optical module is an optical fiber module used for a transmission rate of 10Gbps. 10G optical modules can transmit data through optical fiber media to achieve high bandwidth and long-distance data transmission. 10G optical modules usually use standardized packaging and interfaces to connect to network devices (such as switches, routers, servers, etc.).

The 10G SFP+ 40KM optical module is also called 10G ER in the industry. It is equipped with a 1550nm EML laser and PIN detector, a duplex LC interface, and a maximum transmission rate of 10.3G. It complies with the SFP+ MSA and 10G Ethernet standards and has a long transmission distance through single-mode optical fiber. Up to 40km.

10G ER optical modules are used for long-distance interconnection of network equipment. The general connection method is to insert the 40G ER optical modules into the 10G switch, and then insert the duplex LC single-mode OS2 jumper. The other end of the jumper is connected to the patch panel. On the Internet, distribution frames are usually connected to underground optical cables to achieve long-distance transmission. The connection diagram is shown below.

 

SFP+ MSA package with duplex LC connector

Class 1 laser safety certified

Single power supply 3.3V

Operating temperature: - (Commercial) 0 to 70 degree

 

 

	10G SFP+ ER		0 degree to 70 degree
	SFP+
	-1~+4dBm
	40km		＜-16dBm
	1550nm		3 Years

 

 

1.Dust cap:Protects fiber optic connectors, fiber optic adapters, optical interfaces of optical modules, and ports of other equipment from external environmental pollution and external damage.
2.Skirt:Used to ensure a good overlap between the optical module and the optical interface of the device, and exists only on SFP encapsulated optical modules.
3.Label:Used to identify the key parameters of the optical module and the manufacturer's information, etc.
4.Connector:Used for connecting between optical modules and single boards, transmitting signals, supplying power to optical modules, etc.
5.Shell:Protect internal components, mainly 1*9 shell and SFP shell two kinds of.
6.Receiving interface (Rx):Fiber optic receiving interface.
7.Transmit Interface (Tx):Fiber optic sending interface.
8.Handle Clip :Used for pulling and inserting the optical module, and in order to identify the convenience of different bands corresponds to the color of the pull handle buckle is not the same.

 

 

 

 

 

 

Beliebte label: 10g sfp+ er, China 10g sfp+ er suppliers, manufacturers, factory